Clicky

4 American Standard Champion 4 Toilet Problems (Fixed!)

4 American Standard Champion 4 Toilet Problems (Fixed!)


Even the top-notch toilets will have issues that need solving to continue using them. The American Standard Champion 4 is one of the brand’s most popular toilet types, giving an impressive performance, but this piece focuses on American Standard Champion 4 problems.

The commonly seen problems with American Standard Champion 4 include phantom flushing, which occurs when leakage occurs around the flush seal after the seal has absorbed water for several years. The other issues are weak, slow, or no flush and leaks between the bowl and the tank.  

The American Standard Champion 4 toilets provide comfort and convenience, and you will receive when the unit works flawlessly. As a result, it is critical to understand the issues and solve them appropriately.

American Standard Champion 4 flush valve

American Standard Champion 4 Toilet Problems And Solutions (Quick Fix)

If you’re in a hurry, look at this table that lists the issues with the American Standard Champion 4 toilet and their corresponding fixes.

 ProblemRecommended Solution
 1. The toilet is not flushing properlyCheck the chain to make sure it is not loose
 2. The toilet has a slow flushUse distilled white vinegar to remove the mineral buildup
 3. Toilet leaking between tank and bowlTighten the nuts in an alternating manner to keep the tank stable.
 4. Toilet has a weak flushUse electrical plastic hooks

Don’t let problems with your American Standard Champion 4 drive you crazy. All you need to do is examine your toilet to identify the reasons for the faults and then fix them.

The following section delves into the toilet’s problems and their fixes.

1. American Standard Champion 4 Toilet Not Flushing Properly

One of these issues is most likely to blame if your American Standard Champion 4 toilet has flushing issues: Your toilet tank has too little water, issues with the flapper, a blockage in the drain, the toilet, or the flange.

a) Weak Flush

A weak flush could stem from the absence of slats on the toilet tank lid. The slats allow air into the tank so that when the toilet flushes down, air can fill up the space left by the water.

Too much seal will prevent water from dropping quickly.

A series of jets or holes around the toilet bowl could also cause a weak flush.

Fix

You can use electrical plastic hooks. Alternatively, follow the steps below:

Step 1

Take the toilet tank lid off and check that the water level is half or a quarter inch from the top. Alternatively, you can adjust the float, so it’s just at the top.

Twisting the screw can make the float go up or down.

Step 2

Check the chain to make sure it is not too loose.

Step 3

Take a 1-inch PVC coupling and slide it in so the water level is slightly higher. However, this will increase the flush from 1.28 to 1.3, 1.4, or 1.5.

b) Slow Flush

Mineral buildup in your toilet will cause it to have a slow flush.

Fix

Use a stiff-bristle toilet brush and distilled white vinegar to dissolve the mineral buildup and regain the toilet’s flushing ability. Consider adding a water softener as well to prevent this issue from recurring in the future.

American Standard Champion 4 flush valve problems

2. American Standard Champion 4 Toilet Leaking Between Tank And Bowl

It occurs when you fail to compress the tank and the bowl gasket.

Fix

Apply downward pressure to keep the tank level as you tighten the nuts in an alternating manner until the tank is stable. Avoid over-tightening the nuts since doing so will cause the porcelain to crack.

If there’s still a leak between the tank and bowl, the gasket is either worn or not compatible with your toilet. Replace the gasket with a new Corky tank to bowl the gasket.

How Do You Fix The American Standard Champion 4 Toilet? (Replacing The Gasket)

Follow the steps below to fix your faulty American Standard 4 toilet.

Step 1

Turn off your toilet’s water supply, then flush the toilet to empty the tank.

Step 2

Lift the toilet tank lid.

Step 3

Pull up the gasket and run your fingers around it to check for bubbles. The bubbles can lift a part of the gasket off, causing a leak.

Step 4

Turn the gasket clockwise until it snaps the first time. Hold it with your other hand as you give it around ten twists till you feel it disengaged.

Step 5

Pull the gasket out and replace it with the new one. Turn it about six times until it clicks.

Step 6

Turn the water back on.

The gasket kit (View on Amazon) comes with instructions to help you with the process.

How Do You Replace The American Standard Champion 4 Flush Valve Seal?

Here are the steps to follow in order to replace the American Standard Champion 4 flush valve seal: (View on Amazon)

Step 1

Turn off the water supply to your toilet and flush it to drain the tank.

Step 2

Unscrew the black nut and remove it.

Step 3

Remove the O-ring using your fingernail or tweezers and replace it with the black O-ring.

Step 4

Remove the green cover and replace the old seal.

Step 5

While lifting the bottom of the cup, place the green cover on and twist until nested.

Step 6

Screw the black nut back on until you hear one soft click and two loud clicks and fit it into the placeholders.

Be sure not to over-tighten the nut, or it could snap off.

Step 7

Use a wet rug to wipe off the flush valve sealing surface.

Step 8

Restore the water supply and allow the toilet tank to fill.

American Standard Champion 4 Gasket Replacement

Step 1

Turn off the valve going to the toilet.

Step 2

Remove the tube from the top of the flush valve.

Step 3

Remove the chain from the flush arm.

Step 4

Pull the tower up and the old seal off. Do this by spinning the toilet tower and lifting the seal straight off the top.

Step 5

You can now slide the new seal over the top of the tower, making sure it fits into the groove.

Rotate it all the way around so that it sits squarely on the groove.

Step 6

Pinch it all the way around and pull at it until it’s even.

Step 7

Reattach your refill hose to the top of the flush valve, connect your chain to the flush handle, and turn the water back on.

American Standard Champion 4 ghost flush

FAQs

1. Does American Standard Champion 4 Have Toilet Problems?

American Standard Champion 4 toilet exhibits significant flaws, like water leaking through the flush seal and ineffective flushing when using 1.6 gallons of water. The toilet needs two flushes to be efficient.

2. How Do You Fix The American Standard Champion 4 Toilet?

To fix the American Standard Champion 4 toilet, you must first troubleshoot it to identify the problems and then use the appropriate tools and processes to rectify the issue. Depending on the extent of the problem, you might need to replace some parts.

Final Remarks On American Standard Champion 4 Toilet Problems

Don’t hurry to hire a professional plumber if you can fix most of the issues with your American Standard Champion 4 toilet yourself. Additionally, fix any problems with your toilet after troubleshooting it, and only replace it as the last option.

Other Interesting Posts To Read:

Recent Posts